Summer fridge warning: These small mistakes can overheat your compressor and cause a blast

At the point when Summer temperatures rise, the refrigerator in your home works even harder than when it is working at average room temperature to keep your food at their safe storage temperatures, which puts a great deal of strain on the compressor. The compressor may overheat, leading to a mechanical breakdown or, in rare cases, a catastrophic pressurised explosion. If your refrigerator does not have adequate ventilation or is overstuffed and requires a proper amount of ventilation and stability for the cooling system to work appropriately and safely over the long term.
Understanding the science of heat pump operation and refrigerant exchange cycles will help to avoid your cooling system becoming a fire hazard; with this document as a guide, containing evidence-based recommendations on how to maintain proper operation and efficiency of your refrigerator for all peak summer months.

For most people to have enough room in the kitchen, they place their refrigerators against the wall; however, this ‘chokes’ the compressor of the refrigerator.

Action: Pull your refrigerator back at least 4 to 6 inches from the back wall.

Reason: This causes the air in the back of the refrigerator to be allowed to escape by providing a ‘chimney effect’ where the hot air can rise and leave. If the hot air is trapped behind the refrigerator, the compressor will operate in a ‘double shift’, thus causing the compressor to burn out!

It may seem reasonable to use ‘maximum cold’ when it is 45 degrees Celsius outside; however, this is a mistake.
Action: Keep your setting at ‘medium’ or about 3 degree Celcius to 5 degree Celcius.
Why: When the setting is at the coldest level, the compressor runs continually without stopping. Compressors that do not ‘rest’ tend to overheat and therefore will fail.

Refrigerators typically produce audible warning signs before failure.
Step: Listen to the noises.
Warning: If you hear a consistent clicking noise every couple of minutes but the refrigerator does not cool, then the start relay is likely overheating.

The dust that builds up on the cooling coils of your refrigerator acts like a giant wool sweater, absorbing heat from the inside of your refrigerator.

Action: To eliminate this dust, unplug your refrigerator and inspect the backside or bottom front of the unit (behind the grill).
Fix: Using a vacuum or a long-handled brush, sweep the accumulated dust and pet hair away.
Impact: Cleaning the dust off your refrigerator will reduce the workload of the compressor by as much as 25 per cent.
PC: Google Gemini

In the event that the refrigerator door does not seal tightly, the refrigerator will work at a loss when it competes against the heat of summer!
Action: Close the refrigerator door on a currency note. Attempt to pull the currency note back out.
If the currency note is easily pulled out, your rubber gasket is not sealing tightly.
How to fix this: Clean the rubber gasket with warm, soapy water to remove grease. If the rubber gasket continues not to seal properly, rub some Vaseline (petroleum jelly) onto the rubber gasket so it can adhere to the metal refrigerator frame better.

Never fill the refrigerator above 70% of its capacity.

Why: The cold air needs to be able to flow freely like water. When you place large pots or plastic bags in front of the refrigerator’s vents, the volume of cold air able to circulate is diminished, creating hot spots, requiring the compressor to work harder even though the refrigerator is full of cold food items.